Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiThere are two controller and core switchin core i will create vlan 94int vl94ip addd and int g1/1switchport mode trunk in the wlcInterface Name Port Vlan Id IP Address Type Ap Mgr Guest-------------------------------- ---- -------- --------------- ...
Hiin core switch in create vlan 94 int vllan 94 192.168.50.254and assign wlc management port 192.168.50.252i make untagged vlan 94 at time WLC installationwith service port i can access WLC GUIwith Management port i am not able to login with out swit...
HiMultiple Vlans for Dyanamic interface for AIR-AP1852I-E-K9 AP for Mobilty is supported or notLike 2504 we can create Multiple vlans for Multiple SSIDBut in Mobility Controller AIR-AP1852I-E-K9 is supported or not for Multiple vlans for More SSIDS
link getting Down & UP for every 12 0r 24 hour
we have to core switch one old network and onther new network
so we make trunk between old and new network
old network trunk configuration
interface GigabitEthernet0/1 switchport trunk encapsulation dot1...
Hi
I need to Make Upgrade IOS for 2960 Switches .
want to make as 6500 Series Switches as TFTP server
How can i make is it possible to upload IOS of 2960 Switch in 6500 series Switches
Thanks,i need understandconfig interface vlan management 0for my network side for example i am using vlan 94config interface vlan management 94 ip add 192.168.50.250 255.255.255.0 192.168.50.254please correct me if am wrong
HiThanksthese setting applied previously also tommorow i am going site need to make wlc gui please advice There are two controller and core switchin core i will create vlan 94int vl94ip addd and int g1/1switchport mode trunk in the wlcInterface Name...
Thanksmanagement 1 94 192.168.50.252 Static Yes N/Aredundancy-management 1 94 0.0.0.0 Static No N/Athese port are already tagged then telling again tagged via cliplease tell how can do this
Thanksmanagement 1 94 192.168.50.252 Static Yes N/Aredundancy-management 1 94 0.0.0.0 Static No N/Athese port are already tagged then telling again tagged via cliplease tell how can do this
