HelloI am experiencing some strange issue with my VOIP in 1 of my branches. our branches are connected thru IP VPN and 1 of our branches are able to call our office in HQ (ringing but no voice) other branches are able to call our office without any ...
Good day!I've been trying to refresh and practicing site to site configuration but i have some issues which i still cannot ping Host B from Host Abelow is my configuration from Router4 to R5-2, by the way in between R4 to R5-2 is connected thru OSPFR...
Good day!
I was designing our up coming office/project and we wanted a redundant links from router up to access layer switch. I have done from core to access switch using HSRP on Core switches. If possible we are planning to add 2 routers and bind ...
I have question if it is possible to block a particular group of extension number to call other extension number....
5XX not allowed to call 2xx, 3xx, 4xx
2xx, 3xx, 4xx not allowed to call 5xx
btw. I'm using 1 Cisco Call Manager 11.5 and telephon...
Hi
I am having the same issue we have checked the power cable and tested it and it it is okay but still I am having same issue with power supply 1
nvironmental alarms:system minor alarm on power-supply 1 power-output-fail (raised 1d00h ago)
backpl...
Hi!i have checked my firewall which was i think blocking and i check and issue command " sh shun " in FWSM and displays blocking (10.10.1.1 - router sub interface for ip phone) and (10.10.1.23 - ip phone). i did negate the shun command to release th...
Hi Joseph,Thank you for your response.Yes, my Core switches are 6500 Series. My Line cards are all Gigabit interfaces and Servers connected on that particular port is 10GB. Actually, when ping drops constantly, it includes disconnection of our all ap...
Hi everyone,I have the same issue with our network where ping drops. We have firewall module in our Core switches as Active/Standby mode and servers are connected to Core 1 and Core 2 in port G2/43. Our server has 2x10GB interface which is connecte...
@Chris IzattI have some few inquireies about your configuration.... are all R1, R2 and R3 have routing protocol running in between? If yes, are the inside network included in the routing?if No, there are missing configurations from your routers which...