Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, a supervisor engine in one of our Catalyst 9410R chassis has failed and needs to be replaced. We have a dual SUP setup so there is still one functioning active sup engine in the chassis. Cisco has sent a replacement part but the new one has a...
Hi all,
We are using AD for user auhentication in Jabber for Windows but have a separate LDAP directory as contact source. The Jabber clients are configured as phone only mode.
We would like to use the user ID used for Jabber login also for the lo...
Hello,
I have recently stumbled over an odd problem while upgrading Jabber for Windows on some clients to version 11.9. (also tested with 12.0)
We use a meta directory server (C4B XPhone Directory Server) to combine several contact sources. We are...
Hi all,
I have configured a 5508 controller to connect local and Flexconnect APs. There is an additional 2504 for termination of a guest Internet access SSID. On the 5508 and 2504 I have configured SSID "guest1" and anchoring. This is working as expe...
Hi all,I am currently struggling with a odd Jabber directory integration issue. We currently use Windows Jabber version 11.6 and have setup an LDAP metadirectory server to provide users with contact data from different sources. Our Jabber config is ...
Hi Leo,thank you very much for your reply.When booting the new sup engine with this command does it only boot the newimage or will it also be installed ?Best regardsAndreas
Hi Jonathan,
Thank you very much for the fast response. Unfortunately both proposed solutions would not be possible with our setup.As we only have a very small user base (20+) I will implement a workaround by creating individual jabber-config.xml f...
Hello Jaime,
thank you for your fast reply. I have created a test-xml and assigned it to one of the devices. In thisxml I have changed the directory section as follows:
<Directory> <DirectoryServerType>CDI</DirectoryServerType> <PrimaryServerName...
Hello Vincent,
managed to implement it as follows:
Create new LDIF to activate rwm module
rwm_moduleAdd.ldif:
dn: cn=module{0},cn=configchangetype: modifyadd: olcModuleLoadolcModuleLoad: rwm
Add to LDAP config:
ldapmodify -D "cn=admin,cn=config" -x ...
Dear Vincent,
I am currently facing the same issue with Jabber always using ANR and would like to try your solution with rewriting but unfortunately I do not know how to implement this with our OpenLdap. Our LDAP server is configured to use OLC and I...
