Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I'm trying to configure 802.1x policy on Cisco ISE (v1.2.x) which will authenticate devices using computer certificates.i have configured the AP and the policy on the ISE server and when i'm trying to connect i'm getting an error message says:...
Hey,While trying to configure a new template (in this case NTP template) i'm not able to change template settings and getting the fields in grey (see image attached). does anyone knows why?Also if i already have an NTP server configured on my devices...
Hi,i have configured an ASA with very simple setup and AnyConnect access, my client manage to connect and recive an IP but i can't access resources in the inside network.here is the configuration:ASA Version 8.0(4) !hostname ASA-LABenable password XX...
Hi,i have the following topology:2x 877 routers, one interface from each router (port Fa0 which belongs to the router internal switch) is connected to the 2960 switch, the switch himself configured with default settings, flat with one vlan.I have con...
Hello to the Community,Currently we own two 7301 routers which act as LNS servers in our network,While connecting directly to those routers, on a separate interface, and send some pings I'm getting some response times of over 200ms.Those routers has ...
Hi Afroz, Thanks for your quick replay, i know how to configure NTP using CLI template but on my devices i already have NTP server configured (each is using different IP) and i was looking for a way to configure on all devices (more then 500) a new N...
Hi MiKa,here are the outputs:ASA-LAB# show vpn-sessiondb svc Session Type: SVCUsername : xxxx Index : 22Assigned IP : 192.168.31.1 Public IP : x.x.x.xProtocol : Clientless SSL-Tunnel DTLS-TunnelLicense ...
Hi Javier,Did you manage to find a solution to this issue? i'm facing the same problem with PI1.2 but i noticed it's releated to the router IOS image, it occurs only on 15.0(1)M8 where on 12.2(24)T4 it won't.i wonder...
Hi,looking on your new design I think it will be best for use Layer-3 redundancy between the core switches and the edge routers, for example you can use OSPF and BFD and gain a sub-second fail-over between them.As for the access layer - does these sw...
