Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, There is any conflict between OTV on ASR1002 and wccp on Wave-694 configured in the same scenario?My scenario is 3 sites with ASR1002 for OTV cloud, a wave-694 at each site configured for wccp, and a 6807 in VSS mode as CORE-LAN. I wan to know if...
Hi everyone, I have a question...I going to install two Nexus 7009 with three N7K-F248XP-25 modules on each one, I am planning to create 3 VDC, but at the initial configuration the system does not show the Ethernet ports of these modules, even with ...
Hi there,I need to design an access network for 48 ports ADSL, using as CPE SOHO77, and DSLAM 6260. My question is: If is extremally neccesary use a 7200 or 6400 as aggregator router?, I need a low cost solution, could I use a 2600 or 3600 as aggreg...
Hello Finn,Thanks very much for your answer, the idea is like you said, Wave-694 running wccp, we are worried is about the traffic could be encapsulated into OTV before to be redirected to the Wave... We wants to do is, that specific traffic (not all...
Hi,I have a question...I going to install two Nexus 7009 with three N7K-F248XP-25 modules on each one, I am planning to create 3 VDC, but at the initial configuration the system does not show the ethernets ports of these modules, even with the show ...
Hello,We have ASA 5510 ver 8.0(5)We are having some VPN site-to-site desconnection problem, the VPN were working ok, but now the connection are not stabished, we getting this log messages:ASA01-BA-TC# sh logSyslog logging: enabled Facility: 20 ...
hello Rossdavidson,can you tell me how you solved the problem, because I am getting the same trouble, after the ACS 4.0 installation I cannot login...thanks in advance
