balakrishnansenthil

Hi Team,We facing issue with one of our nexus 9000 access switch which is showing "(Hot standby in b...

Thanks for your support

Issue has been resolved after unplug and plug the network cable on Telco end, May I know how to rese...

Hi Team, We have two fex's connected with our Nexus 5K (N5K-C5548UP) and also enable Jumbo frames po...

We will try to reload and this is old circuit.. which was worked since Long years

Thanks Nipun We already open telco case to review but between this service is working without any is...

After reload this switch issue resolved

I would like to know procedure for reload SUP module... don't want to disturb with traffic impact.

Hi Team, We planning to reload our Supervisor module due to bug CSCuq09636, Currently our switch run...

Hi Team, We have switch WS-3750G-24PS with running version of 12.2 , Can it be possible upgrade to 1...

Understood, Thanks for your update We got this below suggestion our portal.. Seems like depending of...

We unable run "netflow config" with current using version of 15.2(5r)E1. with WS-C2960L-16TS-LL mode...

Hi , We have a lot of network devices, we want to see "show logging" output with every devices.Curre...

Hi Team,We want to create script for "show logging" command to verify with all of our network device...