Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Currently I have an MX, 2 MS switches and 2 Meraki APs with 5 VLANs. All layers 3 and DHCP is all done on MX if I want to configure all layer 3 routing from one of the MX switch and make MX as just FW, can I just clone my current network and change a...
If we change this setting in CUCM Service Parameter "Default Interregion Max Audio Bit Rate" to a different codec from default G729 to G711 do we need to restart the CUCM service for this to take effect?
I have MX75, wanted to block some IoT devices going out other than the port and IPs that needs to talk to their respective servers. There was limited logging on the MX itself on cloud so configured Syslog locally and collected the files and checked. ...
I opened a case last night not sure which time zone case was handled unlike Cisco TAC we know kind of and re-queue the case to local time zone if needed. Is it possible to find that in Meraki support and requeue to get support local time?
Thanks for the quick response again. I also found this URL explained even better https://documentation.meraki.com/Architectures_and_Best_Practices/Recommended_Topologies/MX_and_MS_Basic_Recommended_Layer_3_TopologyThanks again!
Thank you both for your quick response. Didn't realize I can't do switch config's on the cloned network. I'm not good on API/scripting. I will do one VLAN to begin with to test, when I do that even though I don't have all the VLAN/subnets moved, duri...
Maren, Thanks for the quick response. If we have to reset the Regions which is pretty much all devices for this customer. I guess restarting the CUCM service is better anyways which will force restart all devices here.
