HiWe have PA-MC-STM1 CARD on 7600 series router. This card is for channelized E1 support. I need to configured full bandwidth on this card. How can i do that.I am connecting my router with service provider and at the other end second router is connec...
HiI have one question about SSM Module failure in the ASA.If SSM module on the primary ASA is failed then failover of the ASA will happen or not ?If i restart the SSM module on primary ASA, failover of the ASA will happen or not.Regards,Jatin
HiRecently I have installed ASA 5520 with ASA-SSM-20 module.I can view the event alerts but I have following questions1. Can I get the alerts from ASA-SSM module to my syslog or any other monitoring tool 2. I can monitor the event alerts from ASDM b...
HiI have two call managers ver 4.0. Both call managers are configured in cluster. One is Publisher and another is Subscriber.Now i want to load balance on these two call managers. I want that half of the phone should get registered on one call manage...
HiI am trying to configure Network access restriction. I want that user should do only telnet in the router from any ip address. I am selecting port 23 in the option but it is not working.I have to give * in the port then only it works.Do we need to ...
Dear JackkoI am not agree with the configuration replication on the standby SSM.What i have observed that configuration synch will happen which is defined in the ASA box but the configuration which we have done on the SSM module will not get replicat...
Yes...when my publisher goes down all the phones are able to register with subscriber.Now i want to share call processing load on both the servers as per the requirement. When i do that some phone are able to register but other phones from the same d...
Hi..Thanks for your reply.In my case i m using IP Address only instead of hostname. My problem is bit confusing. If i shutdown the Publisher all the phone are getting registered in subscriber. which means that cluster is working fine.But when i try t...