Hello. We are connecting a legacy Bogen HTA-250A to a UC560 via a Cyber Data SIP Paging Adapter.We have the analog end done. Can hear the "Audio test" from the adapter to the overhead speakers.The issue remains with getting the UC560 and Adapter to...
Hello, we are installing a UC560. The customer has a Bogen HTA-250A and an ATA 186.The ATA was not used to connect to the Bogen before. They'd like to integrate it to use the IP phones to page in the plant area via the Overhead system.I've added th...
Hello, has anyone experienced this issue where VM to Email asks for Authentication password needs to be reentered and saved monthly?I have a customer that is complaining about this. Please advise.Thank you, Paul
Hello, is there any known issues when deploying 2 separate SPA525G2 phones at locations when each is sharing a line?It seems that when one is registered teh other get kicked off.These are using SSL VPN to connect back to the main office.If you need m...
Hello, SR500 is EOL. What is the recommended replacement to use at a remote office/teleworker?Cisco 800 series have been used in the past, are these the best remote router still?Please advise. Thank you, Paul
So, do not add any additional SIP, ephone, dn configuration?Just add this?ephone-dn 6number 1111 no-reg primarydescription IP-Paging6name QMI Pagepaging ip 239.1.1.6 port 2000Make sure on the Multicast Config page of the Cyber Data has the same Mult...
John, I changed it back to a VLAN 1 IP (172.16.x.x) to try another route.Let's say I was starting from the beginning, what would the best way to configure the UC560 then carry the settings over to the Cyber Data SIP Paging Adapter?Thank you. Paul
John, I deleted the entire sh run. If you need it back let me know.I set the Cyber Data device to a static IP od 10.1.1.5 on VLAN 100.I did set the multicast for the three default Cisco Paging dn's and added a fourth for the Cyber Data.I will run th...
