Hello. We are connecting a legacy Bogen HTA-250A to a UC560 via a Cyber Data SIP Paging Adapter.
We have the analog end done. Can hear the "Audio test" from the adapter to the overhead speakers.
The issue remains with getting the UC560 and Adapter to communicate to each other.
Per Cisco SMB Support and Cyber Data's site the "callbox" configuration process was used.
Here is what was entered into the UC560:
QMI-UC560(config)#
QMI-UC560(config)#
QMI-UC560(config)#ip dhcp pool Callbox
QMI-UC560(dhcp-config)#host 172.16.11.112 255.255.248.0
QMI-UC560(dhcp-config)#hardware-address 0020.F702.1A6E
QMI-UC560(dhcp-config)#default-router 172.16.9.101
QMI-UC560(dhcp-config)#
QMI-UC560(dhcp-config)#voice register global
QMI-UC560(config-register-global)#mode cme
QMI-UC560(config-register-global)#source-address 10.1.1.1 port 5060
QMI-UC560(config-register-global)#max-dn 6
QMI-UC560(config-register-global)#max-pool 1
QMI-UC560(config-register-global)#
QMI-UC560(config-register-global)#
QMI-UC560(config-register-global)#voice register dn 6
QMI-UC560(config-register-dn)#number 1212
QMI-UC560(config-register-dn)#no-reg
QMI-UC560(config-register-dn)#
QMI-UC560(config-register-dn)#voice register pool 1
QMI-UC560(config-register-pool)#id mac 0020.F702.1A6E
QMI-UC560(config-register-pool)#number 1 dn 6
QMI-UC560(config-register-pool)#dtmf-relay rtp-nte
QMI-UC560(config-register-pool)#username 1212 password 1212
QMI-UC560(config-register-pool)#codec g711ulaw
QMI-UC560(config-register-pool)#
QMI-UC560(config-register-pool)#no vad
QMI-UC560(config-register-pool)#
QMI-UC560(config-register-pool)#end
The UC560 being IP 172.16.9.101 and the Adapter being 172.16.11.112 (via DHCP)
I can provide screen captures of teh C.D. Adapter as well.
Any thoughts, or if you had success setting one of these up I would greatly appreciate it.
Thanks, Paul
