Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Curent setup C40 codec (multiway enabled) VCS 7.1 Conference Factroy configured MCU4510 ad-hoc template configured. This is all working correctly.ScenarioC40 using multiway adds 3 additional particiapants to the conference. When the C40 (Host) leaves...
Can someone point me to a readme document for this engineering special. I'm looking to see if this is a mandatory ES that I need to apply to 7.0(2) or if it fixes only certain issues.
When you install UCCX 7.x and run the setup wizard, you are asked to choose an Admin account as the last step. Aside from losing Admin Access to the UCCX AppAdmin and having to reconfigure any scripts that may be using that account for authentication...
I am looking for a Cisco document that gives me theIP through-put on 2901, 2911 and 2921 routers with Policy based routing applied.IOS version 15.1.3TOther processes EIGRP Stub VLAN routing SRST MGCP gateway (analog and PRI)Any and al...
You are probably running into this defect.
Problem Description: Make RestCall Step not working properly
Resolution Summary:
- Identified the defect : CSCuy92967, This will be fixed in UCCX 11.5.
I had the same issue a while back. sounds like you are hitting the same bug. What version of VCS following bug was fixed in 7.2.2CSCub76176Symptoms: Calls from unregistered endpoints, behind a NAT, into a VCS Expressway may be dropped at 15 minutes.C...
Create a test application add the script and then add a trigger for testing. Once confirmed set the live application with the script that you tested.-Dave
