Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm looking for general config for VDSL PPPoE on a Cisco 867VAE I have a block of Public IP addresses and I only what to use this router to give out the public IP addresses for devices. So no NAT or Firewall, No Private IP's, no other services - ju...
I'm trying to upgrade the firmware but I keep getting file not found. Using http://url/firmware.loads in the Upgrade Rule. The error I get is "File Not Found". If I cut and past the Upgrade Rule URL in a browser, it immediately goes to download th...
I've got both a RV340W and RV345P at two separate locations that will not pass traffic to the Internet. Latest firmware on both. When I try to ping (using the Ping in the Administration/Diagnostic Page) the ISP default gateway or even 8.8.8.8 I ge...
I have the latest CME on a 2911 router with 7975 phones running SCCP. I'm trying out the new 8861 SIP phone but it keeps going offline and registering. As well, I can place a call but it disconnects the call after about a minute. I don't have thi...
Does the cisco867vae-k9 support dual wan such that the VDSL is the primary WAN but if that goes down it switches to the secondary WAN (GE cable). And when the VDSL is up again it switches back to the primary.
Thank you. I figured it out.I needed to unpack all the zip files along with the .loads file. Once I did that, the firmware upgrade went through.The instructions never said to do that or wasn't clear as far as I could tell. I had the firmware in zip f...
It's not something as basic as that...I think someone would have come across the issue since it's quite specific. I can place it in several other environments with the same config and it works - just not in the case I mentioned.
If you can reprod...
POS item ... Cisco will not replace this unit if it's bricked. I updated the firmware and got the red light and it's bricked. Do not buy this product or take your own risk. Do not waste your time with support.
Okay will look at that but...
What is the password so I can get into the Admin on the 8861 phone? I want to be able to set the voice VLAN and the Data VLAN like the Skinny 7975's. Right now it's picking up the data vlan so maybe that's the problem....
