Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a new FTD 2140 device with version 6.2.3 but the FMC virtual is running 6.2.2
I have another FTD units running under FMC and I am wondering if during the FMC upgrade from 6.2.2 to 6.2.3 will be any service disruption on the managed devices.
...
Is it possible to point the EX 90 to a custom phone book? The unit is using TC5.1.4 and it is natively register to CUCM 8.6. Customer has a several EX90 units across the network and they want a custom phone book just for the Video units, something li...
Have a Cat 4507 with Supervisor 7-E, setup configuration to send NetFLow information to an external server, everything worked great but after 2 weeks, the exporter is showing zero packets sent and the following error is at the console:Nov 5 15:52:35...
I have a 3rd party IVR system which requieres a SIP trunk to the CUCM cluster to call out Cisco IP Phones and also to the PSTN. After the SIP trunk provisioning on both sides calls from Cisco IP Phones to the IVR system are working, calls from the IV...
Is it possible to manipulate a specific B Channel to use a dialpeer? For example on a T1 with 24 channels, I need the last 4 B-channels to choose an specific dialpeer, same concepts as matching incoming DID's but on a B-Channel slot.If a call arrives...
I am doing some research and looking specifically for wccp redirection to Ironport based on IDFW. It says that feature is not supported but later on you mentioned:Not that I have heard. We have - ironport wccp- botnet - also with ironport- CSC module...
Which IOS version and Supervisor are you running?Mine is: cat4500e-universal.SPA.03.02.00.SG.150-2.SG.binWS-X45-SUP7-EStill haven't been able to find any information about the error.Oscar Perez
Hello Christian:I am running into the same issue where we need to allow some You Tube Channels but not the rest of you tube. Your workaround with the Video ID works great but we have some channels with 300+ videos. You mentioned on your last post:...
Already did the debug, the call is not getting to the Voice GW. I am using all significant digits on the SIP trunk config. And I have a pattern that match the digits, 9.1[2-9]XX[2-9]XXXXXX or 9.[2-9]XXXXXX for local calls. But again the call is not h...
