I dont think it is possible! ... View more

Did you managed to find a solution for this? How was it resolved? ... View more

What was the problem? -Joe ... View more

This is nice information. We have been looking for training material for Cisco PI. Thank you. ... View more

You script may be correct. Just check you are using this against submode commands? As the transport input command will be in submode of line vty *. The Baseline Template also allows you to verify commands within a sub-configuration section by using a “SubMode Block”. The Baseline Template must be configured in Advanced Mode to allow SubMode Blocks. Under submode use following : Submode :           [#line vty .*#] Followed by your commands : "+transport input [#.*#] ssh" or "+transport input [#(\btelnet\b)?#] ssh"  -Thanks Joe ... View more

Its is very helpful! Thanks... ... View more

You can use commandsets. The commandsets are a set of one or more CLI commands. You can define a commandset while creating a Baseline template in the Advanced mode. The features of the commandsets are: • If the commands in commandset are in a submode (ip/interface etc.) a submode command must be specified for such a commandset. • Commandsets can have one or more child commandsets. • Child commandsets inherit parent's sub-mode command. You can define commandsets that have to be checked before running the actual commands. The features of the prerequisite commandsets are: • A commandset can have another commandset as its prerequisite. • A prerequisite commandset is used only for comparison and is not deployed onto the device. • A commandset is compared with the config only if its prerequisite condition is satisfied. LMS evaluates the commandsets in different ways depending on whether you have defined the commandset as Parent or Prerequisite. For example, assume that you have defined two commandsets, commandset1 and commandset2: • Commandset defined as Prerequisite - commandset1 as the Prerequisite of commandset2. When LMS evaluates the Baseline template, it evaluates commandset1 first, and commandset2 next. - If commandset1 does not contain submode and is not present in a device, then commandset2 is not evaluated and the device is displayed in the excluded  list in the compliance report. - If commandset1 contains submode and is not present in applicable submodes, then commandset2 is not evaluated and the device is displayed in the excluded list in the compliance report. • Commandset defined as Parent - commandset1 as the Parent of commandset2. When LMS evaluates the Baseline template, it evaluates commandset1 first, and commandset2 next. - If either of these commandsets is missing, the template is considered non-compliant. -Joe ... View more

If you go to CCO and find your hardware type and upgrade available, it should show the latest IOS for your devices. That is the simplest way to find out options. -Joe ... View more

As LMS is able to send the email notification according to log. Are you sure your SMTP Server is entertaining it properly? Can you use some freeware tool like blat.exe on the LMS server to try to send an email and see it works fine. You can either download it from http://sourceforge.net/projects/blat/files/ OR it is usually present in Wind28K server @ C:\Windows\System32. Check and shae updates. Joe ... View more

Please check if SMTP server is properly configured on regdaemon.xml. You can share that file as well. Also, just check there is no duplicate entry for DFM Notifications. Gracias George ... View more

Without error no one can help. Please share the error you see and latest content of syslog.log. ... View more