The dial-peer is not routing the call, using the voip network. When the call goes, I got an unassigned number error: Successful Calls = 0, Failed Calls = 8, Incomplete Calls = 0 Last Disconnect Text is "unassigned number (1)", The Call Flow is: (011...

Hi Everyone, Is it possible to set on Cisco 7960 + 7914 module a BLF SD lamp, so the secretary can see an incoming calls on it (amber light)? Currently, she can only when the user is busy (red light). When you set the shared line on Cisco 7960, it w...

Hello everyone, I´m facing an issue about the display internal name in shared line on UCM server version 9.1. The secretary has shared lines in her 7960 phone. When her boss is not in the office, she usually answers the call, however the calling int...

I just got the real traces from RTMT software, but I can only view the call diagram. When I try to view the details messages, the RTMT doesn´t issue them. The hyperlinks don´t work. RTMT module 9.1(001) UCM 9.1.2

Hello Friends,I haven´t seen any ISR configuration about it and when I have got it, that is a little confuse. This is my topology: UCM server>IP network>CUBE>SIP Trunk>ITSPIs it necessary to set up the sip-server under sip-ua?What type of ip address ...