Greetings, I have a 2851 and a 1841 both serving as hub routers in a GRE multipoint configuration. They are both receiving buffer misses and failures on startup. I will post the output of show buffers below:LAB-HUB-RTR#show buffersBuffer elements...
I have been doing some testing with mGRE tunnels and adding ipsec encryption to them so I can route my voip phones through the tunnels. I have found something interesting and looking for an explanation as to why this is.I have 3 sites one of which i...
Mig, Did you ever find out why this happened. This same thing happened to me. I was running a 2811 with 12.4.19 IOS image with a straight through cable and then upgraded to 12.4.24.T8 and now it is requiring a cross over cable to bring that same ...
Just to add to this I have also wiped the config and started with all defaults and still getting buffer failures on boot.Any further suggestions?Thank You
Just curious what you ended using for this? I am trying to do the same thing and was curious if you found a solution using Cisco?Any information you can provide would be appreciated.Adam