Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Which is the best Meraki Layer 3 roaming solution to use, distributed L3 or via a concentrator? What are the relative merits of one over another (apart from not have to buy some MXs of course) and when would you use one over the other?
Could anyone tell me the CATOS command I would need to run to find out the GBIC types in the modules of a Cat4006?
It has a Supervisor Engine II WS-X4013.
I don't have access to the switch and need someone to run the command locally for me.
Thanks
Looking at deploying the the above antenna externally, however it seems there is no specific mounting bracket available from Cisco to enable any adjustment that needs to be made.Has anybody any suggestions as to what to use, are there any 3rd party ...
I'm looking to extend wireless coverage outside the building and was think of using 2600e APs with AIR-ANT2566P4W-R patch antenna mounted externally.Is this a valid combination?I've had a look through various bits of documentation and this antenna se...
I have a 2821 router and need to add another Ethernet port.However, all the Ethernet modules seem to be End of Sale and the suggested replacements are only compatible with the ISRg2 range.What are my options?Thanks
I understand the argument of putting all APs in the same VLAN but I'm just trying to understand the benefits of Distributed L3 vs Concentrator roaming.
Is the main advantage of using a concentrator for roaming that it takes away the load of managin...
Was told this last week regarding Stackwise Virtual Links on Cat 9500 and 9400
9500 SVL support is expected in 16.8.1 which should be on CCO towards end of this month. It will support StackWise Virtual (SVL) on 10G and 40G links for all 9500. Howev...
Not doubting your information at all (and it makes perfect sense) but I can't see any reference to this compatibility in any official documentation.The data sheet does list 1Gb SFPs but doesn't specifically say they can be used in the WAN port.Just w...
Thanks for the quick reply Scott.It's a large building with multiple floors. To keep the broadcast domain smaller the access points on each floor will be separate layer 3 subnets whilst broadcasting the same SSID.Want to make sure that roaming is ava...
