Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can we change between make new call or answer new incoming ringing call priority when pickup the phone handset?Instead of answer the incoming call when I pickup the phone handset while phone is ringing; I would like to make a new call.For example: My...
Hi all,I have 2 WiSMs and one 5508 WLC. All of them are same subnet and connected to same 6509. They are also on same Network Device Group on the ACS. I use 3CDaemon as my FTP/TFTP server. I try to download webauth Bundle file to the controllers. I a...
Hi all,I use the subnet 10.9.16.0 /20 for the public wifi at out hospital. This is for Internet only; not any hospital inside networks. We use 172.16.0.0 /12 for our inside networks and of course the public wifi clients get ip address via our inside...
Hi all,I have a pair of physical ASA servers v4.1. Now I need to virtualize them. Do I need to buy any new license? Or I am able to transfer the existing licence from the appliances to the virtual servers.In case I am able to transfer license from th...
Thank you for quick response Inayath! I am running 12.2-54 on my 4506E. Because my linecard is pulled from another 4500 (not in service/production); do I need to consider about firmware of the line card prior to install into 4506E? For example with ...
Leolaohoo,I changed the ip address and Primary controller name under High Availability; but it did not work.But, with Scott Fella's method, it works just fine. I just need to set the newer code controller as master, then reset APs in other controller...
Hi Ranraju,For instance, switch 2 needs to be replaced. On the new switch before connect it to the stack, do i need to do:switch 1 renumber 2copy run startPower it off, then connect stackwise cable.Regards.
Tiago,I use ACS ver 4.1 and I do have allow anonymous in-band PAC provisioning; allow authenticated in-band PAC provisioning checked. Do you have any idea where else do I have to look?Thanks.
jedubois!I use Cisco ACS as my radius. For laptops, instead using pre-shared key, I use radius to authenticated the laptop. I create user/password on AD (username is laptop name). On laptop under Intel Proset/Wireless utility, I create a profile with...
