Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good evening everyone,
I'm deploying an OSPF design and had a question or two:
I'm going to be creating an area 0 for my corporate office, which will be my ABR, and plan on making my other sites area 1 or area 2 for each new site, maybe even just lea...
Good morning everyone,
I have experienced this phenomenon in UCCX enough times that I'm finally ready to do something about it. I have a uccx publisher and subscriber that communicate over a VPN tunnel, however, if the tunnel ever flaps it can wreak ...
Hello everyone and thanks for the assistance! Can someone point me in the right direction as to why you would want to advertise a /25 in BGP, but then do an aggregrate /24 summary only in the same process? I'm thrown off by this:
router bgp XXXXnetw...
Good morning everyone,I'm having an issue with a cloud provider that will not allow traffic to be initiated from their end on a certain SA.I did the debug 1(27) and see my ASA reaching out and them essentially timing out. I've read about this and eve...
I have followed that well written document and still get that same screen I referenced. It asked me if I want to erase all startup config. Is it possible something was set that would cause this?
Thank you for the reply, but nothing in there speaks to the error I receive. I’m gathering that it must have been disabled though as it doesn’t take me into the initial configuration setup where I can say no
@Joseph W. Doherty I was looking over best practices with making sites their own area, remote sites, even if I made them all a single area. Thoughts? I realize I could put everything in area 0, but wanted to think long term and as of right now I won'...
Thanks! I'll take this in consideration. I don't foresee any issues with using what we described and I would use stubby if I wanted default, but this should get me what I need. Putting wan links in other areas could cause issues.
