In one of our conference rooms (small huddle room; 4 chairs) we are using a DX70 as a telepresence endpoint with the Android firmware and using the HDMI out to project to a 55" TV. We have gotten the push from administration to switch the room to CE software so that it is the same experience for users as our other conference rooms with SX endpoints. Did the upgrade yesterday and quickly found out that Cisco has disabled the HDMI out port. Is this by design? It was working in Android, why have we taken a step backwards? Any workarounds? Is it in the pipeline to be activated? ETA? ... View more

I have a situation where we are doing a European deployment with CUCM 11.5 and E1 connection to PSTN The client dials 90XXXXXXXXX to reach a national number The client dials 900XXXX... to reach an international number My PSTN provider does not accept the 0 or 00 when receiving a call from us (nor do they present it when sending a call to our gateway) so I have pre-dot patterns set up (90.XX and 900.XX etc) to handle the outbound calls. The issue is that the client finds it very weird to look at the phone number on the display of the phone without the leading 0's. They get the feeling like they didnt dial it. Is there a way for us to send the numbers to the PSTN without the 0 while displaying on the phone with the 0? Thanks in advance! ... View more

We're having an issue with DTMF reception with UCCX when someone enters a string of digits quickly into the IVR. Usually the entire string is not collected. We are connected to ITSP via SIP trunk ITSP --> dtmf-relay rtp-nte sip-kpml <-- CUBE --> dtmf-relay rtp-nte sip-kpml <-- CUCM In CUCM, SIP trunk has no MTP required, DTMF is set to RFC2833 or OOB We do not want to enable MTP on SIP trunk ... View more

I have a CUCM setup (11.5(1)) with a SIP trunk towards a CUBE In my Line Appearance I have filled in what I wish to display in calling ID when calling external yet it always takes the Display Caller ID Any ideas guys? A check box Im missing somewhere? ... View more

Performed an update to sipdx70.10-2-5-212 this past weekend and we have several DX70s behaving poorly after that. The phone registers and is functional for a minute or two after reboot. Then it looses network connectivity. These are the console logs: 08/15/2016 10:54:33 TCP connection timed out 08/15/2016 10:54:34 CUCM CUCM.domain.com closed TCP connection 08/15/2016 10:54:51 TFTP Timeout: CTLSEPXXXXXXXXXX.tlv I have factory defaulted my device and it functions again on sipdx70.10-2-5-212 Once I begin installing updates from the Play Store, it begins to fail again. I've narrowed it down to the Google app and Google Hangouts. As soon as either of these apps is installed, the phone looses all network connectivity. I've tried downgrading and with the same versions of those apps, the phone works normally. If the firmware is upgraded, the phone doesn't work anymore unless I downgrade those apps to defaults... ... View more