About nathancielieska

nathancielieska · 06-19-2013

Thanks everyone in advance.Here is my situation.1 Node (Primary) that is version *****************************************************XXX-ISE01/admin# sh versionCisco Application Deployment Engine OS Release: 2.0ADE-OS Build Version: 2.0.2.103ADE-OS ...

nathancielieska · 11-07-2007

Thanks in advance.I have a situation where i am terminating 3 T1's on a 2620 router from one provider, and a 10mbit Metro E from another provider.I have a firewall behind the router that is NAT'ing out some addresses. 5 of these addresses are Static'...

nathancielieska · 10-16-2007

All,The issue is i have widespread network connectivity problems that seem to be pointing to a switching situation. Our SQL connectivity to 2 highly visible and mission critical applications are seeing hiccups which are basically screwing up data. I ...

nathancielieska · 10-11-2007

All,I had a situation where traffic needed to be blocked from one subinterface on the ASA to another, Security-level was setup the same with appropriate NAT and intra security level permissions. The thing was that the ACL needed to be placed signifyi...

nathancielieska · 06-20-2013

Thanks for your help Charles.Best Regards,Nate

nathancielieska · 06-20-2013

Charles,Good Stuff, thanks for taking the time to write that out. A quick followup. Do you see any requirements or gotchas related specifically upgrading from 1.1.0.665 to 1.1.4 or to your knowledge should I just be able to do a direct upgrade? I'll ...

nathancielieska · 06-21-2008

Metab,If i am reading this right, within each vlan you would like users from vlan 1 and vlan 10 to communicate with anyone in remaining vlans (for example 5,7,15... whatever number).So in your above configuration.. this is what you are allowing withi...

nathancielieska · 10-16-2007

conduits are the big thing.You will need to make an access-list containing all of your conduit statements. This access-list will need to be applied inbound on the outside interface using:access-group in interface outsideThats the biggest difference,...

nathancielieska · 10-16-2007

So if you mean you have configured a PIX/ASA for "timeout conn 24:00:00"Then an idle TCP connection will timeout after 24 hours.The first thing i would ask is if that this connection in reality, is idle for 24 hours. If it is.. is it a well known po...

Member Since	‎10-11-2007 04:33 AM
Date Last Visited	‎01-30-2020 12:28 PM
Posts	30
Total Helpful Votes Received	19

User Statistics

User Activity

Tricky ISE Upgrade

Policy Routing: Route Map Config Check

show tech for 4000 series switch

ASA Subinterface Access-List Application

Tricky ISE Upgrade

Tricky ISE Upgrade

Re: vlan map ACL

Re: Pix(6.3(3)) to PIX (7.0 or 7.2(2) conversion

Re: ASA timeouts