Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone have jumbo frames running on this switch?Using ICMP Echo as my test protocol, I can reach 1552 bytes in frame size ... but at 1553 and beyond (1578, 1932, 2090, 4138, 8978, 9014) , the switch swallows them.When I physically swap out the S...
How does one reboot Nexus using SNMP?'Normally, I reboot IOS gear using:snmpset -c {private} {switch|router|whatever} tsMsgSend.0 i 2 tsMsgSend OBJECT-TYPE SYNTAX INTEGER { nothing(1), ...
Apparently, on the N5K, the SPAN function can induce back-pressure on the ingress interface.Does this happen with any other platform? Searching www.cisco.com, seems to me that this only applies to the N5K ... but perhaps this effect has only been /d...
Does anyone know of an on-line calculator which can be used to predict which member of an LACP channel will carry the packet, given source / destination MAC address (or IP address or TCP port)?I've found tutorials on how to perform the XOR/modulo cal...
Where do I report MIB file errors? The current v2.tar.gz contains the following:guru$ snmptranslateDid not find 'cldRegulatoryDomain' in module CISCO-LWAPP-DOT11-MIB (/usr/share/snmp/mibs/Cisco/CISCO-LWAPP-AP-MIB)Did not find 'CtsSgaclMonitorMode' i...
I've been poking at this question intermittently ... and I'm stumbling in finding a definitive source 'knowledge base' article.Still, at the moment, it seems to me that the N5K has a unique feature here, the ability to shield ingress (source) traffic...
I haven't heard anything back ... but thinking about this ... it is perhaps not reasonable to implement storm-control on a pure software platform (e.g. N1KV) ... without rate-limiters in hardware, perhaps it is difficult or even impossible to impleme...
Hi Bilal,That's helpful, thank you.A peer on another discussion forum suggests the following:'I doubt that you can find one [an LACP calculator] due to the fact that LAG hashing is hardcoded in switch controller and therefore is chipset specific (e...
Hi Vlad,So, a few times a year, I grab the latest MIB file collection from ftp.cisco.com/pub/mibs and update my network mgmt stations.In the current collection, some MIB files reference Object Values which are not defined anywhere, as you have noted....
