STUART KENDRICK
Level 1
Level 1
Member since ‎01-11-2002
‎08-18-2017

User Statistics

  • 82 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 5 Helpful votes Received
Recent Badges
70 Discussion Posts
40 Discussion Posts
40 Replies
5 Discussion Posts
50 Discussion Posts
30 Replies
30 Discussion Posts
60 Discussion Posts
80 Discussion Posts
20 Discussion Posts

User Activity

Does anyone have jumbo frames running on this switch?Using ICMP Echo as my test protocol, I can reach 1552 bytes in frame size ... but at 1553 and beyond (1578, 1932, 2090, 4138, 8978, 9014) , the switch swallows them.When I physically swap out the S...
How does one reboot Nexus using SNMP?'Normally, I reboot IOS gear using:snmpset -c {private} {switch|router|whatever} tsMsgSend.0 i 2               tsMsgSend OBJECT-TYPE                   SYNTAX  INTEGER {                        nothing(1),          ...
Apparently, on the N5K, the SPAN function can induce back-pressure on the ingress interface.Does this happen with any other platform?  Searching www.cisco.com, seems to me that this only applies to the N5K ... but perhaps this effect has only been /d...
Does anyone know of an on-line calculator which can be used to predict which member of an LACP channel will carry the packet, given source / destination MAC address (or IP address or TCP port)?I've found tutorials on how to perform the XOR/modulo cal...
Where do I report MIB file errors?  The current v2.tar.gz contains the following:guru$ snmptranslateDid not find 'cldRegulatoryDomain' in module CISCO-LWAPP-DOT11-MIB (/usr/share/snmp/mibs/Cisco/CISCO-LWAPP-AP-MIB)Did not find 'CtsSgaclMonitorMode' i...
Community Statistics
Member Since ‎01-11-2002 10:37 AM
Date Last Visited ‎08-18-2017 04:03 AM
Posts 82
Total Helpful Votes Received 5
Helpful Votes From