Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,
I have a couple of 48 port Cisco SG550X switches (L3) to which many of my access devices are connected. The 2 switches are connected to each other and this port is configured as a Trunk. For redundancy, I have configured VRRP between them...
Hi All,
I have a Cisco SG550X which needs to be connected to a DELL server. The Cisco SG550X has SFP+ (10G) ports, but the DELL server has 10G Ethernet ports. Could Cisco GLC-10G-T SFP+ transceiver module be used to connect the switch and the DELL ...
Hi All,
Wanted to confirm on whether the below mentioned switches would support IPsec VPN configuration for configuring a VPN tunnel between 2 sites??
1. Cisco 3850 Catalyst switch
2. Cisco SG550X Small Business Switches
Have checked the data sh...
Had configured a cisco EX90 with a static ip address of 172.19.100.40 and after a few days, when trying to connect the EX90 to the network, it was going to the maintenance mode and was giving an error like " The system has encountered with a problem ...
Hi,We have deployed some cisco 2602-E access points in one of our clients place. The signal strength found in the laptops is very good, but the signal strength found in the smartphones is very weak and its fluctuating.What is the issue with this and ...
Hi IIiya,
Had a few questions regarding the SFP+ ports in Cisco SG550X series switches
Please find the attached figure for your reference. Wanted to confirm some details about the ports
1. Are the ports marked in "Blue"the OOB management ports ...
Hi Scott,Thanks for your reply.The connectivity is fine as we have observed good signal strengths.But we have observed fluctuations in the signals. What could be a possible reason for the fluctuations..??The feedbacks that we have got from the users ...
