Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys.. a simple one... I need to bulk migrate different APs (3700s, 2600s, 3800s, 2700s) from one 5520 WLC to another (physically relocating each one in turn to a new DC).I am looking to use a template on Cisco Prime to do this and amending the Pr...
Hi,SwitchingMy DC Core Switches comprise of 2 x Nexus 7009 switches running with VPC configured between them. They run in Primary Secondary mode.I have a SPAN destination port setup on Primary Core switch which is connected to an appliance that colle...
Hi,I have recently installed a Meraki MS120 switch at a customer site. the switch is uplinked to a Draytek router which is handling dhcp.I have some windows devices and a printer connected to the MS120 switch. they have all picked up a dhcp address...
Hi, I have today installed a new IO Module into one of our chassis (2208XP into a 5508 Chassis). But it has not come online. There are lights on the IO module, however uplinks from that to the FI are down. The ports on the FI are down.Error messsa...
Hi,I have a stack of 3750-x switches, i recently purchsed an IP services license upgrade per switch in the stack so i could run BGP. The license install was successful and it now says the license level is ipservices, however when i try and configure...
Can i just ask if i can add the new RSPAN Vlan across an already used VPC link between the 2 Nexus Core switches that has other multiple vlans going across it? Or would i need to add another physical link between N1 and N2 that is just dedicated for ...
Thank you, this was the issue.I checked and majority of ports were set as enabled on port isolation.I have now changed to disabled and have confirmation that all is working fine.thanks for the tip!
Machines are on the network fine and can access other network services ok. Ping is not working and local firewall on machines have been checked.default gateway has been checked and is configured fine as .1 which is the router.I am not on site so can...
