Hi, I'm trying to configure a egress netflow in a 6500 (VSS) with VS-S720-10G supervisor. I foud some old posts and understood that netflow wasn't supported on 6500 but i found a new document and it seems that netflow is supported in Supervisor Engin...
Hi, I'm facing some issues with failover and Cisco UCS Virtual Interface Card 1280. I found some information regarding M81KR:Cisco UCS M81KR has fabric failoverThe Cisco UCS M81KR offers fabric failover, which enables interface failover at a physica...
Hi,Do you know if it´s possible mix the topologys dual-homed with single-homed?For example:Two N5k, connected to 6 N2k with dual-homed and connected to 2 N2k with single-homed.Thanks in advance,
Hello, I´m facing some EOBC restarting every week in a CISCO7609-S with RSP720-3CXL-GE supervisor: Mar 3 08:23:04.690 BRA: %ETSEC-SP-3-RESTART: Interface EOBC0/0 Restarted Due to IEVENT_BABR ErrorMar 5 17:43:43.712 BRA: %ETSEC-3-RESTART: Interface...
Hi carlos, It worked :-) I just needed to change the FaultId, I guess that this number is different in each enviroment.clear_mo.pl .-fId 643849 change the ID from this F17457 I also tried to follow the same procedure for an Warning error on the same ...
Hi, I'm looking for some documentation. I'm not sure, but I guess that ip flow egress export capture only egress flows that were software routed.Regards,
Hi Jerry, Yes, that is exactly what we want to do. we already have some N2k as singled-homed and we want to connect one server in two different nexus, then we need dual-homed topology Thanks a lot.
I got this message yesterday in one router that is running a new version SRE2 (We are performing the upgrade of all routers in the network to this version):c7600rsp72043-advipservicesk9-mz.122-33.SRE2.binSo, i was looking for some problem with this v...