Hello,
Any idea how to monitor DMVPN using snmp polling method.
I am interesting to get the numbers of peer UP here an example below:
XXXXXXXXX-121#show dmvpnLegend: Attrb --> S - Static, D - Dynamic, I - Incomplete N - NATed, L - Local, X -...
Hello
I would like to know how to perfom a downgrade firmware from ASR 903 with RSP-2.
The case is the router already have been upgraded to a newer version IOS and my purpose is to downgrade also the firmware.
There no documentation about this. How ...
In GNS 3 lab i am tring to transport routes from R32 to R20. (both routers are PE in the MPLS)
In R32 I have a eBGP adjacency with R1 and learning many routes.
In router R32 the rutes adverticed from R1 is inserted in VRF INTERNET:
ip vrf INTERNE...
According to the documentation from CISCO following this link:
http://www.cisco.com/c/en/us/support/docs/ip/simple-network-management-protocol-snmp/13506-snmp-traps.html#trps
This is the only feature supported:
NHRP Extension MIB
The NHRP Extensi...
I am dealing with the same problem, even if we upgrade to :
Cisco IOS Software, C2960X Software (C2960X-UNIVERSALK9-M), Version 15.2(5)E, RELEASE SOFTWARE (fc1)
The switch dosen´t recocgnize any other switch.
Port remains always Down.
Stack...
Hello,
Is not the fpd version from the modules (IM, example:A900-IMA8S1Z or A900-IMA2Z ) that is upgraded.
Is something else, because the RSP needed twice reboot before become active.
It´s happening when you upgrade to a uper IOS version, done today ...
Hello,
During the IOS upgrade there are some modules interfase (IM) that the hardware are upgraded to a newer firmware version.
I thing that this command is the one to check the version:
show hw-module all fpd
Example:==== ====================== ===...
Yes,
check you files, should be inside the directory issu/
dir bootflash:issu/
(here you should find your xxxxx.bin file
Then from the prompt EXEC:
request platform software expand file bootflash:/issu/asr900rsp2-universalk9_npe.03.17.02.S.156-1.S2-s...
