Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
We have an issue with the cameras of 2 codec MX700 with CE SW version 8.2.1 . We have enabled the option "Motormovedetection " in both codec, the issueis when in the middle of a call camera stops responding and does not move .We need to resta...
Hello I was wondering if it was possible to check the AP's temperature from a controller 5508 which is associated with from the GUI without WCS or Prime.Regards.
Hello we have a 2800 appliance, and we'd like to upgrade from this IOS version:c2800nm-adventerprisek9_sna-mz.124-15.T17.binTo this one from 15.x, c2800nm-advsecurityk9-mz.151-4.M7.bin.Is there any license we'd need to install to be able to do this ?...
Hello, we have 2 ASA 5520, are we are thinking of upgrading them from ASA 8.4(5) and the ASDM 7.0(2), the device it's a 2GB Ram, with a Intel Pentium Celeron 2GhZ. I was wondering which version was the most stable, we are having an increased of clien...
Hello, we have a 6500 chassis, with version 12.x, and we'd like to configure syslog commands to send it to our collector, but with VRF's configured, it's not possible to do that, we've seen that we'd need a version 15.x, which could be a good version...
Hi ,
We also have the same problem makes approximately one month that we do not send notifications.
I have Cisco TAC in open talk with the logistics staff do not know what causes.
regards
Hi,
The customer really wanted to activate the voice recognition option of the camera. Is the choice we have indicated ? We have not done the factory reset because the codec provision has been made a month ago and is new.
Hello Freerk, thanks for your reply, about the MESH AP is the only thing I could find around the guides too, I guess there's no other way around than using a WCS or Cisco Prime, right?
