About tazi mahmoud

tazi mahmoud · 11-23-2020

Hello, I'm facing a problem where CUBE initiates two times INVITE after Refer Failure event with 480...

tazi mahmoud · 03-12-2019

Hi Community, we have an UCCE 10.5 environment and we want to integrate cisco Jabber only for agents...

tazi mahmoud · 01-07-2019

Hello, After installing the ICM 11.5 on my Lab environment, i get the error when i want lo launch th...

tazi mahmoud · 12-20-2016

no, i want to establish user based ACL, when i try with packet tracer i get no ipv4 associated to us...

tazi mahmoud · 12-20-2016

Hello, I'm facing a problem that cisco ASA 5506-X doesn't get the user logged ip address, regards

tazi mahmoud · 12-14-2016

Hello, I have an ASA 5506-X with firepower service, i have license for IPS and URL Filtering but i s...

tazi mahmoud · 11-25-2016

the scenario is bellow PhoneA(ext120) Calls PhoneB(ext100) Phone B wants to transfer the call to Pho...

tazi mahmoud · 11-25-2016

Hello, I'm facing a situation where i want to transfer an incoming call using my second extension nu...

tazi mahmoud · 11-24-2016

Hello, I would like to show BRI line status (Like BLF) on cisco ip phone Yhe bri line is connected t...

tazi mahmoud · 11-21-2016

I tried two possibilities Phone already configured on call manager and new phone with auto registrat...

tazi mahmoud · 11-21-2016

To be sure i permit any to any from ip phones to cucm networks and from cucm to ip phones networks

tazi mahmoud · 11-21-2016

Hello, I have an architecture where ip phones and CUCM are in two separate networks trough Juniper F...

tazi mahmoud · 11-21-2016

It was a CSS problem on incoming calls configuration

tazi mahmoud · 11-21-2016

Hello Chris, thank you for your answer, yes i have the DN(line number) configured on the phone in th...

tazi mahmoud · 11-21-2016

Hello, I want to route incoming calls in BRI interface to ip phone extension registered with CUCM. T...

CUBE initiates an INVITE after 480 Refer Failure