Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone,I'm Currently Running Cisco Unified CM Administration System version: 8.6.2.21900-5. Issue : I'm trying to assign a DID to user who doesn't have a physical Cisco phone. Can I do this on CUCM ? if so how ?Thanks in advance.Soofi
Hi,I have an easy one for you guys,I am currently running WLC - 2100 with software version : 7.0.98.0My question is : How to change the existing password ( not reset ) but change the password with the web interface ?If that cant be done, then my gue...
Hello Everyone,I am running a three stackable 3750 ( ws-c3750g-24t )switches together with version 12.2. These swicthes are dedicated to our SAN devices ( Dell Equalogic). System MTU is set to 1500.ISSUE :----> Off latetly we are seeing some perfo...
Hello All,I have a very simple and a weird issue. I have a 2960 which I am using as a unmanageable switch. So a month back I assigned port # 5 on the switch to one of the windows server. Everything was working fine until all of sudden it stopped wor...
Hello AllI am using a SA 5520 with the following versionCisco Adaptive Security Appliance Software Version 8.0(3)Device Manager Version 6.0(3)We have a new device which will be used for the multiple video conference ( MCU ) its from lifesize. The iss...
Amit Thanks for the response.( so according to your response )In this case -> My System MTU is set to 1500 and I can change it to 1998 bytes ). Right ?-> Also, Since My jumbo frame are already set to 9000 So cant beyond that .. Correct ?Please see...
Did you ran both commands or just the "show" command?No, I ran both the commands.So it's SWITCH < --- cable --- > Router? Is this it?YesAlso, I think the output from sh log posted on the previous thread was heading us into wrong direction. The rea...
Nope! That didnt fixed the issue . Even after replacing the cable the issue continues and I did ran same command here is the outputInterface Speed Local pair Pair length Remote pair Pair status--------- ----- ---------- ------------------ ---...
Thanks Leo, for the response here is the output from the command. And yes the link was down and came back up.sh cable tdr interface gi0/5TDR test last run on: June 06 22:48:36Interface Speed Local pair Pair length Remote pair Pair status------...
Thanks for input.I tried the steps you have suggested, please see below for the output. Also, as stated earlier the port in question is not connected to a windows server. But it is been conencted to a linksys home router 4 port + 1 port ( WAN ) .Also...
