Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to run dual stack IP schemes over an ipsec-protected tunnel interface on IOS? I am able to assign the IPv6 addresses like a normal interface on both ends however when i try to ping across the tunnel with IPv6 there is no response. Here...
Ive been trying to get a lab scenario to work that i came up with on my own. Not expecting it to be so troublesome of course. I have the topology pictured below:The only issue is that R2 cant ping R3 and vice-versa. All the routes show up in the BGP ...
I have CUCM and CUC 6.0.1 and i am trying to do a basic dial plan for my house. I had this working before but i lost all my virtual machines and have to redo my config. I have four phones (ext 1000, 1001, 1002, and 1003). The call flow should work as...
I just got phone service from Cox and am having issues getting inside -> outside and outside -> inside dialing working. I have a C1760 acting as my MGCP gateway with an FXO card. I have a DN that rings all my phones that i want my inward calls to rou...
I have an issue with ACLs I have FTP forwarded via PAT to an internal server on my edge router. I have a rather extensive ACL that denies spider servers and certain ranges i know to be spammers. The issue lies in FTP. When the ACL is applied to my ou...
Ah i see. The spokes need to know how to get to their respective parther's ip addresses. I figured they would get to there by hopping across the hub router without an issue. Thanks!
I have made some progress since posting this. I recieve calls from the PSTN correctly now. I had to set the attendant DN in CUCM to the pilot number for my hunt group and a destination-pattern dial peer specifying CUCM as the ipv4 target. In short, i...
