Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, All. I've come upon an issue with the 7965 Model Phones and the "Display On If Incomign Call" option. By default, CUCM has that option disabled. In order to combat this, I have modified a Common Phone Profile deployed to all phones. This has p...
Hello, All.I am testing a bulk upgrade of 7960 phones to 7965 using TAPS on CUCM 8.6.x. The 7960 phones each have a primary DN assigned to them and are currently routable. Unfortunately BAT does not seem to be playing nice..Method 1I left TAPS at the...
Hello, All!I am building a CUP 8.6 lab and would like to get a better understanding of how to bulk setup end users for Jabber. I've outlined the steps I know I want to complete, and how I think they should be completed. Would you mind reviewing and l...
Hello, All!I'd like to selectively block outbound CallerID on a SIP trunk. I've come up with two methods to block the CLID, but I'd like to know if there are better methods.From CUCMCreate a secondary SIP Trunk with Privacy enabled. Create a Route Li...
Hello, All!I would like to setup my CallManager 8.6.2 lab so that by default 7965 phones have their display come on when there is an incoming call. Based on the CUCM documentation, I configured both the Common Phone Profile and Enterprise Parameters ...
Hello, Yahsiel.Yes, I have confirmed the Override option is checked under Common Phone Profile. I believe the override is actually taking affect when the phone is auto-registered, as you would expect. However, the device is then overriding the Common...
Hello, All!I have continued testing this in my lab and have come up with the following results.When setting up a new device, TAPS will generate an error if the DN is already in existence across multiple devices.If replacing a device, you must use the...
Have I lost my marbles? I was under the impression TAPS could be leveraged to bulk upgrade from one model phone to another. However, after a call with Cisco TAC I was told TAPS isn't used when a DN already exists. Now I know I've used TAPS to repl...
Hello, Nishant. Thank you for your quick reply.I read the same document and specifically looked at issue 3.Issue 3After the DN is entered in a call to TAPS, the user receives this message: Unable to fetch a unique record even with the external phone ...
