Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, How do I verify multiple paths available to a route in OSPF I have three paths available to a route. I can see two equal cost paths shown in the routing table. The third higher metric path doesn't show up in the routing table When I disable th...
Hi,we have cisco 6509 switch with ws-x6748-GE blade We have configured layer2 portchannel with a HP blade switchchannel-group mode is set to 'Active'Portchannel establishes but I could see several portchannels are created Pasting the sh etherch summa...
Hi,We have a faulty FWSM module in Cisco 6509 switch in Active/Standby cluster modeWe have purchased a refurbished FWSM module to replace it. It has the same FWSM OS 4.0 (4) and is in factory default configuration What procedures should I follow to m...
Hi All,I have a simple etherchannel configurationI configured ports gi 0/2/1 and gi 0/2/2 as channel-group 21 mode activeand then configured int po21 as trunkingThe ports gi 0/2/1 and gi 0/2/2 got the config from int po21when I then add gi 0/2/3 as ...
Hi All,We have cisco 6506 switch, I made the port as switchportI couldnt enter switchport trunk encap dot1qafter entring switchport trunk ?I could see allow, pruning etc but not the encapsulationThe switchport is made as trunk and operating properlyJ...
Thanks for the reply Reza. Is there a way to find all paths available in the ospf database.I just wanted to know the total number of paths available to an route in ospf area
Hi Paul,one more quick question. There was no VTP configuration at all on the switch.Will VTP be enabled on an out of the box switch and also what is the default mode on themyes after configuring the VTP mode Transparent, I was able to see the vlans...
