Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi AllI have two N7k switches connected to FW using vPC and running OSPF over vPC and it work fine in both N7K switches and stable, the line card is F3, the issue is for example:1. when rebooting the first switch, the OSPF between second switch and F...
Hi,i want to migrate the vlan from Cat6500 to N9k and currently using vlan from this range "3968 to 4095", and this range already reserved in N9K, my question is can use the same vlan ? if yes.is there any special configuration? Thanks
Hi,when migrated the NTP configuration from c3560 to c9300 i have this error: NTP Core (ERROR): Invalid-NAK error at 659 192.168.10.140<-172.17.3.110this ip address 192.168.10.140 is management switch and 172.17.3.110 is ntp server. anyone can help. ...
Hi, i have migrated the configuration from C3750 to cat9300 and i want to configure below configuration under the interface " power inline consumption 8000" but this command not supported , what is the equivalent command on Cat9300. Thanks
Hi, I have CAT9300 switches after upgrading to "cat9k_iosxe.16.06.04a.SPA.bin: it gave me these error. interface TwentyFiveGigE1/1/1^% Invalid input detected at '^' marker.interface TwentyFiveGigE1/1/2^% Invalid input detected at '^' marker Thanks
Hi Balaji,because in current C6500 some vlans used from the same range, and i want to migrate the same configuration. in this case what should i do ? Thanks
Hi Marce,i have turned off the authentication and the error disappeared but ntp not sync, and configured the authentication again, the error came back again. Thanks
Hi Marcel: show ntp informationNtp Software Name : Cisco-ntpv4Ntp Software Version : Cisco-ntpv4-1.0Ntp Software Vendor : CISCONtp System Type : Cisco IOS / X86#sh ntp associationsaddress ref clock st when poll reach delay offset disp~172.17.3.110 .I...
