Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have installed one Cisco SX20 VC in our office last week only. Since then we are receiving auto call with name Cisco with no ip address. Everyday approx. 250 calls we are getting on VC.VC Network Configuration: Configured with Public static IP add...
Hi,In my network setup i have two core switches which run on HSRP and above the core we have two MPLS router which is runs HSRP on its LAN port.We have single interconnect VLAN for the router and core switches.From core router we have pointed static ...
For encryption , If the user is sending mail from the microsoft outlook, and sending as a confidential mail, then is it possible to trigger this mail on ironport by configuring any policy and get encrypt at the recipient end. Regards,wajid dabir
I want to configure one policy for incoming mail i.e. any attachment in incoming are of following type then it should directly drop the mail.e.g. msc, msi, wsf, add, mde. How do i configure policy above requirement, kindly someone tell me the steps ...
I am getting a below error for one domain.users are sending the mail to this domain are getting softbounce with the error Reason:4.1.0 - unknown address error (451 Temporary local problem- please try later}find error in detail in attachment.want to c...
Thanks for your reply Vasilii..We have GW 10.60.12.1 only.But how my HSRP will sync when we loose the WAN primary link.We don't have interconnectivity link between two router.This are provided by the service provider and they Run BGP on their WAN net...
Hi All, We are also facing some what same issue with our new SX20 VC system.Issue is,When we are making a call to polycom VC(HDX 8000), we are getting an error "Cannot connect to call", However when same VC is dialling my VC IP then call is eslablish...
Dear Sir,I contact with the destination postmaster and replied the below logs for the issue. I just want to verify on which end the problem is present. 2014-03-13 12:23:30 SMTP connection from (smtp.rblbank.com) [180.179.117.92]:63543 I=[119.18.57.70...
Thanks Martin for your valueable reply, it helps me a lot to face the customer.Dear martin, can we check the mail queue of ironport, i mean total mails coming in queue for delivery.In tophosts active receipent only shows the some domain detail, i w...
