Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings,I went to factory reset a 7931G running SCCP after a failed attempt to change to SIP code.The phone reboots, gets an IP, says "Upgrading". I can then see it hit my TFTP server and grab: term31.default.loadsAfter this, the spash screen come...
I have a C1310 LAP that I need to downgrade to Autonomous, but it constantly reboots.Is there anyway to stop this so I can get into it and load a full ios code?*Mar 1 00:00:24.599: %LWAPP-3-CLIENTERRORLOG: LWAPP Crypto Init: could not start PKI sess...
What is the best way to authenticate MAC, Windows and iPhones users on Cisco 1300 and 1100 series APs? I would prefer username/password using local radius if possible. Would like a paid consultant that can assist with the configuration.Thank youDav...
Greetings,I am running some polycom phones through a Cisco 860 router (no CCME/SRST stuff). Just a plain jane router, and it works fine, in fact any router I've tried, except the 851 works fine.If I try and run the same phones through a Cisco 851 ro...
Greetings,I have some 861 routers where I want to send VoIP traffic over an EZVPN and keep all other data traffice over the WAN. The 861 seems to have a very limited set of QoS features. I can setup class-maps by presedence, vlan or ip rtp, and can...
Looks promising, but still rebooting:Press RETURN to get started!*Mar 1 00:00:04.711: %LWAPP-3-CLIENTEVENTLOG: Read and initialized AP event log (contains, 100 messages)*Mar 1 00:00:06.716: %LINK-3-UPDOWN: Interface FastEthernet0, changed state to ...
Sounds good. Do you know the best way to match ESP packets on an 861 with limited QoS features?match options are:Router(config-cmap)#match ? access-group Access group any Any packets class-map Class map cos ...
