Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Please make sure you disable all these checkboxes you have set right away since this will easily exhaust your server cpu/memory/desk resources. Select “Restore Defaults” then enable Debugging level ONLY for ENG (NO Xdebugging at all). You should ...
Hi,
You may check the below trace analysis and find the same steps for your call:
http://docwiki.cisco.com/wiki/Guide_to_reading_MIVR_logs_for_Telephony_Issues_-_ICD_Call_Flow
Some hints:
- Use your Calling number to locate your "Call.receive...
Hi,
To see Script steps in Engine logs (MIVR), you need to enable "ENG" level into Debugging from CCX Serviceability page --> Trace --> Configuration (no need to set any of XDebugging levels). Then place a test call and collect Engine logs. Search ...
Hi,
When you do changes on CSQ configuration, new CSQ record ID will be created in database while the older record is preserved but marked "Inactive" (CSQ ID will be shown in the report by default). You will see multiple entries in the report sinc...
Hi Pragash,
A defect was opened for Jabber on Apple iOS 12.0 timing out when application runs in the background. When Jabber is brought to foreground, notifications start coming through. This is not a Jabber specific defect, but rather an Apple i...
