I am going to migrate my WLC 2504 to a WLC 9800 L-C My WLC 2504 is using two ports1 port connected to the network1 port connected to a Cisco 2811 (for guest output) Note: the Cisco 2811 only works at 10 and 100 mb These same connections will pass t...

  I have a Mobility Express, currently my SSIDs with PSK and MAC filtering with that I'm working without any problem. But now I want to configure a SSID with 802.1x (RADIUS Active Directory) I came across this guide which I have followed but can't au...

  I currently have two C9500-48 switches. One of them is in production (with working configuration) And the other switch is in stock (without configuration). Now I want to form a stackwise between both switches. then I will configure both switches to...

  I have a WLC 5520 v8.3.150. My access point is in FlexConnect mode. My SSID is WPA + Mac Filtering. Printers were recently added to my network (bixolon ticket printer). My problem is the following; When I try to connect my printer by DHCP it takes ...

    I have a virtual Prime. I upgraded my Prime 3.1 to prime 3.10. Carry out the process as cisco says it ie; Prime 3.1 ---> 3.7 ---> 3.10 (here cisco says to create a new virtual machine with v3.10 and load the backup of v3.7). My Prime is ok, but I...