Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear,we running cluster of Cisco ASR9001 on IOS XR 6.1.4, and suddenly rack1 crash down and reboot with led 'LC fail' on you can see below the output of show platform command:Node Type State ...
Hello,
we have an issue with asa firewall(9.5) when configuring Anyconnect such as that our public ip address are not configured on outside interface but as a pool for nat, we have private subnet with our service provider (/30) to our router ,and oth...
Hello, We try to use our both dsl line at the same time using load charing with PBR on ASA firewall 9.5
PPPOE interface Config
interface GigabitEthernet0/2 nameif outside security-level 0 pppoe client vpdn group ADSL1 ip address pppoe setroute!inte...
hello,
we have problem in our ASR9001 Ver 4.3.4, after an accidental power off due electrical problem, led LC fail still red and line card (module and interface) not shown as active
see here some output
RP/0/RSP0/CPU0:ASR9001-01#show platform Tue No...
Hi all,Does it possible to configure ASA failover with different IPS module configuration because we have: ASA 5585-X with FirePOWER SSP-10 and ASA 5585-X with IPS SSP-10 Thanks,
Hi,could you please tell me your scenario of connecting your XRv (as BNG) router whith client via IPoE, because Ihave the same but I cant see client mac address in BNG when client attempt to send dhcp request. is command unnumbred address and bundele...
Update !the problem persists after doing turboboot with 5.1.2, line card still in bringdown statewith error: RP/0/RSP0/CPU0:Oct 22 17:17:47.871 : canb-server[152]: %PLATFORM-CANB_SERVER-3-ALARM_INDICATION : Raise alarm from CBC in slot 0/0/CPU0, alar...
Hi,
you can find in attachment the physical diagram
for NAT, actual I use for anyconnect a new ip address (not used for nat )
now how can redirect traffic from outside interface to wan ip address used for anyconnect.
should I apply translation from w...
thank you for response, is it normal if I dont get any output after reloading the line card
I use this command to reboot line card:
ASR9001(admin)#hw-module location 0/0/CPU0 reload
