Hi,
I had a doubt in configuring single interface to multiple wan locations,
Recently one service is provided single ethernet output in HUB location and other 4 ethernets for the respective branch locations.
I need to configure EIGRP on this link.
Sh...
Hi
We have 3 branches in a location and all are interconnected as like a mesh. but the primary is 4 mbps and the secondary is 2 mbps because of this facing some latency issue on this. Herewith i attached a network diagram please suggest to proceed f...
HiKindly explain how to calculate interface traffic utilization using ifInoctets and ifOutOctets. what is the formula that monitoring tools are using to calculating the traffic ? I searched a lot but each one telling different things i totally confus...
Hi Iam having a cisco 3945 router, needs to configure wan links in that. kindly suggest a network module which can support wan configuration and it should be in TJ45,because the service providers are providing connections through RJ45 only. Whether H...
Hi Enrico,
Thanks a lot for your inputs, As you mentioned earlier in the earlier post I will go with EIGRP in the production network.
I will work this topology in the lab setup.
Regards
Dinesh Murthy
Enrico
I have attached a sample topology, needs to advise and suggestions.
If enabled both the protocol EIGRP and OSPF by default router will choose EIGRP because of the metrics. But OSPF link is 100Mbps and EIGRP link is 4Mbps only, because of the m...
Enrico
They are small scale service provider call SKYLINK, they provided a fiber cable connectivity to all our branches, and they placed Dlink fiber switch in the locations.
If I ask about config details, they said VLAN in between the locations, I th...
Hi.
They are not giving exact details, while I enquired they told that enabled VLAN in their and mapped the ports. They placed a switch in our premises and provided a port to connect the link. I think it's just a layer2 path.
Hi Enrico,
I checked with the vendor, they are going to configure VLAN only. they asked me to configure all the four locations in a single(same) subnet. I think just they place a switch in betweens the links.
which protocol needs to configure shall I...
