Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,I'm testing Jabber 9.7 internally on a CUCM9.1/CUPS9.1 deployment, in hopes of using persistent chat rooms.Currently, I have working MUC rooms with 3rd party chat clients, but I think there's a configuration option missing from CUCM or CUPS...
I'd like to prepend text to an existing CNID, so that incoming calls to certain DID come in as "[Support] $originalCNID". Or, worst case scenario, if that's not possible -- just change the CNID all together so that it displays "Support" only.Is th...
Hey guys, just wanted to post this here so it's documented somewhere.If you're running windows in a virtualbox environment, and you run into an issue where UCCX editor hangs at 81% for a while -- finally loads, but won't actually connect to your CCX ...
Hello All,I'm in a bit of a jam. I've got a carrier that only supports sending either rfc2833 or plain g711u inband. I've been told from the uccx TAC that the only dtmf methods supported on uccx are a subscribe/notify model like RFC6665 ('dtmf-relay ...
The session-agent(s) and sip-interface that were associated with cucm were changed to kpml-interworking enabled. kpml-interworking was set to disabled on the SA/SI sides facing our carrier, and rfc2833-mode on that SA was set to preferred.I also turn...
Turns out Acme added an option called "kpml-interworking" in scx 6.4.x (we happen to be running a version behind). Looks like I can upgrade and enable kpml-interworking on the sip-interface for callmanager.. then we should be okay.Fingers crossed!
