Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an ISR 4331 Router (positioned as the internet edge) running on the latest stable version of IOS XE i.e. (16.12.03). For some reason, at unspecific intervals all internet traffic stops working. The only way to resolve the issue is to issue the...
I have an ISE infrastructure connected to a C9800 WLC Cloud (VM). The APs are in Flex mode and the Guest configuration on ISE is working properly for other Groups (Employees and Contractors). As long as the Flex ACL contains permit ip any any, everyt...
Hi all,Just configured a 3750x switch as a DHCP server for some vlans and even though the ip routing is enabled, I am unable to route between vlans. Note that the 3750x serves as a core switch that connects through trunking to 2960s accesss switches....
Use the "terminal monitor" command in privilege exec mode to view the debug information via Telnet and SSH.
Connect only one AP that requires 802.3at and enter the command "power inline auto" under the interface that is connected to the AP.
Ensure ...
To see the debug information via telnet or ssh, you need to enter the command "terminal monitor" from Privilege Exec mode then disconnect the AP and connect it back.
Hello Robert,
I suggest you add VLAN 999 to the allowed VLAN list on the two switches.
The second thing is that because the unifi software is running as a VM and yet is suppose to do VLAN tagging, there are a few things you need to do at the hypervi...
Hi All, After drilling down further, i can see two processes that have extremely high utilization. qfp-ucode-utahcpp_cp_svr I am running version 16.12.03 and per the link below, it seems this should have been resolved any advice to help fix this? ht...
