Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Buenas a todos.Tengo un problema que aun no tengo claro que es, aunque despues de leer varias horas documentos empiezo a pensar cual puede ser el problema, pero necesito confirmarlo.Tenemos dos UC540 SItio A (81...)<----------------------------------...
Hi everybody,I have a multisite configuration with two UC540. All works fine but there is something that it isn't work properly.Scenario: SIte A (81...)<-------------------------------------------> Site B (82...)Calls between sites, no issue.Call ...
Buenas a todos,Tenemos un problema de configuracion de nuestra centralita IP a la hora de resgitrar la SIP trunk.Hasta ahora teniamos una cuenta conTelsome, en la cual no daban el usuario del tipo numero 654347xxxx con su password.El problema es que...
Buenas a todos,Se me ha presentado un nuevo reto y tengo una red en la cual tengo una gateway conectado a una serie de SG500 repartidos por toda la empresa con stacking nativo ( en total son 8 ) por fibra óptica.En un extremo de la empresa, tenemos u...
Hi ,I am interested to find a solution about my RV340 to setup something like a secondary gateway or backup gateway when the forst gateway fail. I don't know if RV340 has the posibility to check the connection tyo internetr, for example, a ping to 8....
Hi Maren,Sorry for late reply. Finally I did it but tThe story changed a litle bit.The provider told me that it's better to use the G711aLaw for differents reasons, but the main reason was that using G729 the issue was still happens. Then, we standar...
Hi Maren,Thanks a lot. let's go in parts.1.- At the beginning the SIP provider told me that de codec must be G711alaw. Now ( and as you say and as I have seen in the log ) the provider send me a INVITE with G711alaw and G729. Maybe this is my salvati...
Hi Maren.Maybe I have to put my problem in a different way.Maybe the right question is: What would be a correct configuration from a factory setting to make it work correctly?The warning that I need a transcoder, I don't know what the implications a...
Hi Maren,Here you are two files.The both debug files are from the UC540 is registered to SIP server ( Site A ) and receive the SIP call.UC540 no voice.txt -> debug file no voice ( Site A where the operator pick up the call )UC540 si voice.txt -> debu...
Hi Maren,I'm sorry for disappearing but I've had a small accident with my bike and I've been out of service.I would like to take up the matter at hand, if you are still available. Best regards.
