Hello,I've got 4x ISE appliance, 2x Administration and 2x PSN1 Administration primary / Monitoring secondary2 Policy Service Node3 Administration secondary / Monitoring Primary4 Policy Service Node Both PSN's are in the same Node Group... ISE is work...
Hello, Today we had electrical issues and our WLC has turned off, after turn on we have seen that the ACLs have changed from 'Permit' to 'Deny'.That happened to all ACLs, we had electrical issues two times and everytime that happened, our ACLs have b...
Hi,I would like to know if is possible to disable COA when an device meet an profile, per example, I have the following profiling policy: Workstation- Windows XP- Windows Vista- Windows 7- Windows 8 Sometimes the device get profiled as 'Workstation',...
Hi,I'm having roaming problems at a customer.I have 1 WLC 5508, software version 7.4.110.0 and 20 AP (AIR-CAP1602I-T-K9) installed on the head office and 15 AP x 3 Branch office.The roaming problem occurs at all sites, even using 2.4 or 5 ghz and wit...
Hi,I'm having some problems with windows profiling.ISE is taking a long time to recognize windows devices, when I connect my laptop to the wireless network, display the device as "unknown", I need to wait some minutes until recognize as Windows 7, Xp...
* is for WLC auto configuration, if you manually change these parameters, * will be removed. Leave as it is now. WLC is adjusting 802.11 radios as needed, don't worry about it now. Were you able to tweak EAP parameters?
*osapiBsnTimer: Jul 01 06:35:33.955: 00:56:cd:bf:b7:e2 802.1x 'timeoutEvt' Timer expired for station 00:56:cd:bf:b7:e2 and for message = M0 Its a issue of 4 way handshake, try to increase following timers: config advanced eap eapol-key-timeoutconfig ...
Hi, I know this is an old thread, i hit the same issue and found information bellow.
You need to configure LDAP for access, local users are not allowed by default.
https://www.cisco.com/c/en/us/support/docs/security/firepower-ngfw/200701-Configuratio...
Aplique o comando "debug capwap console cli" no AP em modo Lightweight, esse comando permite que você acesse o modo de configuração "Configure terminal".
