Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone!
I've configured Application Visibility in WLC 7.6 on 5508 controller and added Netflow export to Cisco Prime Infrastructure 3.1. In PI AVC Data Sources WLC appeared, but input flow record is showing less than 10 per 5 minutes, and i c...
Hello!
We currently planning to implement Netflow Export to Cisco Prime 3.1 from ISR G2 3945 with NBAR2 application recognition for Application Performance monitoring. Now we only configured Netflow monitor and export to PI (only shows http, icmp etc...
Hello everyone! I have connected console cable to my new AIR-CAP2602I, but there is no output from AP. It is connected to 2960-S PoE switch and getting IP address from DHCP server, but i cannot connect to it by telnet or ssh. Only icmp responds. I al...
Hello everyone!Is it possible to change inline ports wan/lan assignments in inline group on WAVE 694/WAVE 7571 with 4/8 port copper gigabit ethernet inline module through telnet or Central Manager?Can any problems occur if cords were plugged in wrong...
Scott, thank you for answer. Cable was successfully checked with cisco 3745 router. After some manipulations with licences on vWLC my AP joined to a vWLC, but still not sending any information to console cable.
