Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a customer with CME requesting Cisco Unified CallConnector for click to dial capabilities from Outlook. However, they are ordering 8945 phones. I do not see these phones listed in the datasheet. Has anyone deployed this with phones other t...
Experts~A customer of mine is using Unity and, under a previous setup, they are receiving voice mails for undeliverable email notifications. They would like this feature turned off, and I am not sure if that is a Unity feature, or an exchange connec...
Interestingly enough, the M4 servers are explicitily not supported according to the Sociaminer virtualization dockwiki.
http://docwiki.cisco.com/wiki/Virtualization_for_Cisco_SocialMiner#Notes_on_UCS_Tested_Reference_Configuration_and_Specs-based_S...
Any resolution on this issue as I am running into the same problem. I am running Unity 4.0(5) and the AD enviroment was just upgaded to 2008 R2. I have recommened the patch to our internal AD admin, but wanted to see anyone hadimplemented with succ...
Yup, upgraded the production to 7.1.2, but that did not fix the issue. I believe that this is a "when in doubt, replace"solution that I am being provided at the moment. I will let you know when it doesn't work out.
Yep, I asked about that as well. I could putty to the box without issue, so why not just FTP or TFTP up the new firmware. Anyway, I think we got sideways on the license issue. So first I need the licenses and get the unit registered on Cisco.com. ...
Chris, sorry for the delay. I was told by TAC that I could not do the load the config file because the firmware version was different. Old, 7.1.2 RMA is 7.0.2. I tried to upgrade it, and that is where I ran into the issues you mention in your post...
