Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So in my building I have a switch closet on each floor with a stack of 3750's. Each floor switch stack has a single fiber link to the core switch (3750) in the server room. Both switches are L3 and I've configured the link between as a dot1q trunk. I...
For some reason, starting today, none of my users are able to download their AnyConnect client from the VPN Portal. When a user types in his or her credentials, the log on completes successfully, but instead of redirecting them to download the client...
So I have a weird issue since I reloaded my ASA 5540's (8.4(7)) this morning. They are in an Active/Standby failover pair and my standby ASA is no longer responding on one interface, but it works on the rest. More specifically, when I try to ping it ...
Hello,I inherited a network with two Cisco ASA 5540's, one connected to the primary ISP and the other connected to the backup ISP. Each ASA has a connection to three switches on the three remaining interfaces. See the diagram below for more details.A...
So I've been using the AnyConnect client for my ASA5540 for a few months now, mostly with success. I am set up for both local authentication as well as RADIUS through my NPS server. Most of the time I am able to connect with no issue at all, however ...
ServerRoom_Int#show etherchannel summaryFlags: D - down P - bundled in port-channel I - stand-alone s - suspended H - Hot-standby (LACP only) R - Layer3 S - Layer2 U - in use f - failed to allocate aggreg...
Bilal,Thanks for your guidance on this, I was actually able to complete this a little more simply than your instructions. I based mine off http://www.cisco.com/c/en/us/support/docs/switches/catalyst-3750-series-switches/69979-cross-stack-etherchannel...
Where is the routing between vlans being done ie. on each closet stack or the core.The core switch has the WLAN vlans which are distributed to the floors. Each floor switch has a vlan for data and voice for that floor on it. Is it just one core switc...
