Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have referred to the route compare script at Github, and customized it and display the result in table format. It's working good on Cisco IOS platform, but it's failed at NXOS... I tried to run it by comparing the "show ip route" results. And got t...
Hi All,Recently my AP failed to join the controller (AIR-CT2504-K9) after I rebooted the controller. I tried to restored factory default to reconfigure them. But it is still failed to join the controller. I'm not able to identify the issue Sysinfo: (...
I installed the new Webex version 42.5.0.22254 recently. Before I used Webex Meeting many years and did not experience any logon issue. After installed the Webex and tried to logon, it was stuck after logon with my email. I can see the spinning wheel...
I got two servers sitting on different location, the servers model/hardware are same. They may need to connect the VPN to external client with Anyconnect. I installed the Anyconnect and configured the VPN gateway's IP address. One server is able to c...
I got two servers sitting on different location, the servers model/hardware are same. They may need to connect the VPN to external client with Anyconnect. I installed the Anyconnect and configured the VPN gateway's IP address. One server is able to c...
I got the high alarms issue on the 10Gbase-SR, that is connecting to the FPGA.... Somehow the port was disconnected unexpectedly....# sh int e1/12 transceiver detailsEthernet1/12transceiver is presenttype is 10Gbase-SRname is CISCO-AVAGOpart number i...
