Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
We are implementing a new wireless network using Cisco.
Our design is using FlexConnect and multiple SSID.
Each SSID is associated to a VLAN:
SSID1 - VLAN 100
SSID2 - VLAN 200
SSID7 - VLAN 700
etc.
The interface for the AP's is a trunk:
interfa...
I have made a small IPv6 network using my Cisco 1812 (12.4(15)T17).-------------------- CONFIGURATION --------------------!ipv6 unicast-routingipv6 cef!ipv6 dhcp pool VLAN10 prefix-delegation pool VLAN10 lifetime infinite infinite dns-server 2001:486...
Hi,I don't know if this is the right place, but here goes.I'm about to document a network and before just collecting a lot of information in some document, I thought I would create some kind of template. Searching for information on best-practices...
Hi,I have the following network connected and configured to a single Cisco 1800 router.VLAN 2 (10.1.20.0/24)|int vlan2, ip address 10.1.20.1|Cisco 1800 ----- int fa0, public ip address ---- Internet|int vlan3, ip address 10.1.30.1|VLAN 3 (10.1.30.0/2...
Hi,We have a setup with two pairs of Nexus 7000 in the following topology:NX7K-1A ---------- NX7K-1B | | | | | |NX7K-2A ---------- NX7K-2BNX7K-1A|B is one pair, and N...
I don't know if I agree a 100% on this.
The AP should be able to just send untagged traffic without knowing the native VLAN, and the switch will put the untagged traffic in the native VLAN specified on the interface.
The native VLAN mismatch is a CDP...
Hi John,No there's no internal DNS server.Although I can see your point in the traffic shouldn't leave the local network, where the web server is located, I'm seeking a solution, where I don't have to install and configure an internal DNS server or m...
Hi,Thank you for the answers.I have already been recommended to change the domain id of one NX7K pair, but because of the weak documentation, I was wondering if you could solve the problem simply by configureing a new vPC system-mac, and if anyone ha...
