Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there, thanks for reading. I need to replace an SG220. I'm seeing that the show run leaves out commands that are viewable via the http GUI. Is there a way to capture ALL of the running config? The GUI backup procedure just grabs the incomplete...
Hi there,Thanks for reading. I've inherited some small business SG220s and SG310s. They're only manageable by HTTPS. Previously, I've locked myself out of devices so many times that i have two connections when enabling AAA or something like that. ...
Hi there,Thanks for reading!I'm having trouble finding shelf kits for our last 9410 inventory. I've found several unrelated 4510 kits. Can I use a 4510 kit to rack mount a 9410? Thanks again!Bob
Hi there,Thanks for reading. I'm having trouble stacking 4 members into a C9300-48U stack. I have redundant PSUs installed and powered. I have all four cables with the Cisco emblem upright (and notched side at bottom). I seated all ends with a nic...
Hi there,Thanks for reading! I'm looking for a way to export a list of associated wired clients. I'm currently looking under Inventory \ Network Devices \ Device Groups \ All Devices \ Device Details \ Clients I see the list I'm looking for but not...
My process somehow dropped the three member switches into rommon. The switches have matching IOS versions. I individually executed switch:boot on each member. Following the process from that point (new members OFF, cable-connected, powered ON) joi...
Hi Joseph,
The throughput testing didn't include hashing. The Table 2 results had this qualifier:
IPSec throughput is measured using a single tunnel with 1400-byte packets, with no Secure Hash Algorithm (SHA) or Message Digest Algorithm 5 (MD5) ...
Hi Joseph,
Thanks again for the white papers.
Can you estimate the overhead hit of SHA 256 and what that will reduce tunnel performances on 50Mb circuits to?
Thanks again,
Bob
Hi Joseph,Thanks for your feedback. Does that mean the those performances rely on using a smaller MTU than 1400? We typically set our tunnel traffic to 1360. In this case we might be able to take advantage of 50Mbps? Also, do you know where to ac...
